Module de commande de moteur L298N pour robots et voitures intelligentes, module de commande de moteur pas à pas à double pont en H 2A/25W ZI

This module uses L298N as the main driver chip, which has the characteristics of strong driving ability, low heat generation and strong anti-interference ability. The chip adopts 15-pin package. The main features are: high working voltage, up to 46V; large output current, instantaneous peak current up to 3A, continuous working current of 2A; rated power 25W. It contains two H-bridge high-voltage and high-current full-bridge drivers, which can be used to drive DC motors and stepper motors, relay coils and other inductive loads, and uses standard logic level signal control; it has two enable control terminals, which allow or prohibit the device from working without being affected by the input signal. There is a logic power input terminal, which makes the internal logic circuit part work at low voltage; it can be connected to an external detection resistor to feed back the change to the control circuit. The chip can drive a two-phase stepper motor or a four-phase stepper motor, or two DC motors. The module can use the built-in 78M05 to take power from the drive power supply part, but in order to avoid damage to the voltage regulator chip, when using a drive voltage greater than 12V, please use an external 5V logic power supply. The module uses large-capacity filter capacitors and freewheeling protection diodes to improve reliability.

Main control chip: L298N Working mode: H-bridge drive (dual-channel) Logic voltage: 5V-7V Logic current: 0-36mA Driving voltage: 5-35V, if power is required from the board, the power supply range is 7V-35V Driving current: 2A (MAX single bridge) Storage temperature: -20℃ to +135℃ Maximum power: 25W Control signal input voltage range: Low level: - 0.3V≤Vin≤1.5V High level: 2.3V≤VinsVss Enable signal input voltage range level: - 0.3≤Vins≤1.5 (control signal invalid) High level: 2.3V≤VinsVss (control signal valid) Color: As Shown Material: PCB

Package Contents: 1 x L298N module 1 x Mini L298N board

Only the above package co